Bukobot 3D Printer Forum

News: Added the Bukobot Parts List (BOM) to Wiki at http://bukobot.com/bukobot-parts-list
Welcome, Guest. Please login or register.
Did you miss your activation email?

Author Topic: Dual Extruder Problem  (Read 158 times)

Lwanmtr

  • Newbie
  • *
  • Posts: 9
    • View Profile
Dual Extruder Problem
« on: April 10, 2014, 04:14:05 AM »
I have a big problem on my Duo.  Extruder 2 is slightly lower than extruder 1.
Using the paper method when i level, #2 grabs the paper before #1..
If i level to extruder 2, then extruder 1 is too far and the filament just gets all squiggly.

This is resulting in #2 dragging accross my prints, pulling them off the bed.  Until now I hadnt noticed it much, but have a larger build and
its killing it every time.

Is there any way to adjust the hot tip?

And yes, I've made sure the x rail is level with the frame, and double and tripple checked the bed leveling.

Thanks.

midoco

  • Newbie
  • *
  • Posts: 24
    • View Profile
Re: Dual Extruder Problem
« Reply #1 on: April 10, 2014, 09:43:26 PM »

Lwanmtr

  • Newbie
  • *
  • Posts: 9
    • View Profile
Re: Dual Extruder Problem
« Reply #2 on: April 10, 2014, 10:53:27 PM »
Thanks

 

BloQcs design by Bloc
SMF 2.0.3 | SMF © 2011, Simple Machines