Received my bukito bot recently, and I haven't been able to get it to talk in Repeiter. I have followed the instructions to install the drivers etc, but it does not respond when in manual control. Was able to control it in manual mode on pronterface, and get the exturder heating up etc. So i am assuming the drivers/firmware is all fine. Also checked it in serial monitor and it responded to the g-code commands. Does anyone have any advice to get it going?
Windows 7 x64
Set the baud rate in the windows settings to 115200 (the highest it can go, though i am fairly sure when you connnect via software, it connects at its own rate anyway).
Installed teenydunino, as well as tried manually installing the driver. Detected on PC as Teeny USB Serial.
Installed lastest Repeiter from website, and connected it the same way as i connected in pronterface,