Bukobot 3D Printer Forum

News: Added the Bukobot Parts List (BOM) to Wiki at http://bukobot.com/bukobot-parts-list
Welcome, Guest. Please login or register.
Did you miss your activation email?

Author Topic: Adding a signature to your forum profile  (Read 292 times)

jit

  • Global Moderator
  • Full Member
  • *****
  • Posts: 174
    • View Profile
Adding a signature to your forum profile
« on: February 12, 2014, 07:50:25 PM »
As Deezmaker's printer models proliferate, there is an increasing tendency for people to get confused.  Someone will ask a question, and then someone else will respond with a reply that applies to a different model of printer.

We can reduce this problem by using signatures.  Click 'Profile' up near the top of the page, go to your Forum Profile, and add a signature that describes which model you have.  It will be displayed at the bottom of every post you make.

If your printer has been modified since Deezmaker first shipped it to you, for example if you are using a newer extruder or a different controller, mention that too in your signature.

It would be quite helpful if you also say which firmware version you are running on your Azteeg controller.  This is shown at the beginning of the long stream of text that is emitted by the Azteeg when you power it up.

And if you create pages on the wiki, make sure you put a notice at the top of the page that says which model(s) the page applies to.  This has already been done for many of the pages that pertain to the Bukobot v1 (see for example http://bukobot.com/jitsbuild-failure-conditions).

Thanks!
« Last Edit: February 12, 2014, 09:16:49 PM by jit »
Bukobot Duo v1

 

BloQcs design by Bloc
SMF 2.0.3 | SMF © 2011, Simple Machines