Bukobot 3D Printer Forum

News: Added the Bukobot Parts List (BOM) to Wiki at http://bukobot.com/bukobot-parts-list
Welcome, Guest. Please login or register.
Did you miss your activation email?

Author Topic: extruder heather connection  (Read 453 times)

stefanz

  • Newbie
  • *
  • Posts: 2
    • View Profile
extruder heather connection
« on: November 02, 2013, 08:35:57 PM »
hi all,

I have my Bukobot V2 fully assembled and wired with the Azteeg X1 controler. But i have a problem with the last two wires.
in the drawing of the Azteeg X1 controller has the connection from the extruder heather to controler a + and - connection, but
the connection wires are both red. http://bukobot.com/_media/:azteeg_x1_wiring.jpg

it does not matter how the two cables are connected the the controler?

thanks


jit

  • Global Moderator
  • Full Member
  • *****
  • Posts: 174
    • View Profile
Re: extruder heather connection
« Reply #1 on: November 02, 2013, 09:38:09 PM »
The heater is symmetrical  --  it's basically a high-power resistor.  The leads can go either way.
Bukobot Duo v1

stefanz

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: extruder heather connection
« Reply #2 on: November 03, 2013, 09:04:15 AM »
thanks.

 

BloQcs design by Bloc
SMF 2.0.3 | SMF © 2011, Simple Machines