Bukobot 3D Printer Forum

News: Added the Bukobot Parts List (BOM) to Wiki at http://bukobot.com/bukobot-parts-list
Welcome, Guest. Please login or register.
Did you miss your activation email?

Show Posts

* Messages | Topics | Attachments

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - cadmodeling777

Pages: [1]
1
 Hopefully it'll still be usable, I hear it cant be laser cut down. theres another plastics store that will sell pre-cut sizes and thicknesses for fairly cheap.

2
General Software (Win, Mac or Linux) / Re: Next steps after setup?
« on: July 17, 2017, 11:33:20 AM »
 I received a roll of pink and a roll of black filament; the black is labelled PLA, but the pink wasn't labelled - is this also PLA? That's the only one I've tried so far and that's using PLA settings, so could be something there. I'll also try to clean the tape with acetone. I'm not currently using masking tape on top of the K-tape.

3
thanks for this valuable information.

4
It sounds to me like you're putting out a little too much plastic, causing it to mound up around the nozzle so that it bumps into it later. You should check your filament diameter, and you may need to adjust your flow rate.

Pages: [1]
BloQcs design by Bloc
SMF 2.0.3 | SMF © 2011, Simple Machines