Bukobot 3D Printer Forum

News: Added the Bukobot Parts List (BOM) to Wiki at http://bukobot.com/bukobot-parts-list
Welcome, Guest. Please login or register.
Did you miss your activation email?

Show Posts

Messages | * Topics | Attachments

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - RobDur

Pages: [1]
1
Electronics & Wiring / HELP assembled but multiple problems
« on: March 03, 2014, 02:17:33 AM »
Ok, I'm done with the assembly, wired as per instructions, software and drivers installed printer settings done as per webpage with classic printer and 250000 baud ( repetier, windows 7 32), printer connects  and when I test flight in manual mode X Y Z travel to home hit the endstop and stop, but that's about it the manual jogs positive or negative don't activate anything the software says Idle, the bed wont heat and the extruder heat stays on for three seconds then it shuts off without heating.
The X axis end stop switch doesn't work, It used to be on the Z axis I switched it it it doesn't work on either one.
I tried it on a rasberry pi and pronterface and the same thing it homes ok I cant do antthing else, could it be that the azteeg X 3 board is defective? 

Pages: [1]
BloQcs design by Bloc
SMF 2.0.3 | SMF © 2011, Simple Machines